單項選擇題What is the function of the command switchport trunk native vlan 999 on a?()

A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. What can be determined about the router from the console output?()

A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.

2.單項選擇題What is the most efficient summarization that R1 can use to advertise its networks to R2()。

A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24

3.多項選擇題Which two statements describe the Cisco implementation of VLANs? ()

A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.

4.單項選擇題

The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do()。

A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router

5.多項選擇題What are three characteristics of the OSPF routing protocol? ()

A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.

最新試題

在Cisco IOS 設備中,啟動配置文件存儲于何處?()

題型:單項選擇題

請參見圖示。下列哪組設備僅包含中間設備?()

題型:單項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中存在多少個廣播域?()

題型:單項選擇題

請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()

題型:單項選擇題

路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()

題型:單項選擇題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:單項選擇題

請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()

題型:單項選擇題

請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()

題型:單項選擇題

請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()

題型:單項選擇題

請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()

題型:單項選擇題