A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
您可能感興趣的試卷
你可能感興趣的試題
A.2 through 1001
B.1 through 1001
C.1 through 1002
D.2 through 1005
A.VTP
B.802.1q
C.IGP
D.ISL
E.802.3u
Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?()
A.It has more than one interface that is connected to the root network segment.
B.It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C.It has a higher MAC address than the elected root bridge.
D.It has a higher bridge ID than the elected root bridge.
A.Broadcast frames are never sent to swiches.
B.Broadcast addresses use an incorrect format for the switching table.
C.A broadcast address will never be the source address of a frame.
D.Broadcasts only use network layer addressing.
E.A broadcast frame is never forwarded by a switch.
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN 2?()
A.This switch has more than one interface connected to the root network segment in VLAN 2.
B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.This switch interface has a higher path cost to the root bridge than another in the topology.
D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
最新試題
What Netflow component can be applied to an interface to track IPv4 traffic?()
What are three factors a network administrator must consider before implementing Netflow in the network?()
Which three are the components of SNMP? ()
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? ()
What command visualizes the general NetFlow data on the command line?()
What are two enhancements that OSPFv3 supports over OSPFv2? ()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()
What are three reasons to collect Netflow data on a company network?()
Which three features are added in SNMPv3 over SNMPv2? ()
What are the Popular destinations for syslog messages to be saved? ()