A. It supports autonegotiation for both ISL and IEEE 802.1Q trunks.
B. It must be disabled on an interface if you do not want the interface to work as a trunk or start negotiation to become a trunk.
C. It is a point-to-multipoint protocol.
D. It is a point-to-point protocol.
E. It is not supported on private VLAN ports or tunneling ports.
您可能感興趣的試卷
你可能感興趣的試題
A.link local
B.area wide
C.AS wide
D.reserved
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
A.A router solicitation is sent on that interface.
B.There is a duplicate address detection on the host interface.
C.The link local address is assigned on the host interface.
D.A neighbor redirect message is sent on the host interface.
A.It will advertise the prefix to all other client peers and non-client peers.
B.It will not advertise the prefix to EBGP peers.
C.It will only advertise the prefix to all other IBGP peers.
D.It will not advertise the prefix to any peers.
Refer to the exhibit. Which switching feature is being tested？（）
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
最新試題
What is true about Unicast RPF in strict mode？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
In GLBP，which router will answer on client ARP requests？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）