A. The VSS switch must be the root bridge for all VLANs and is automatically designated
B. The VSS switch is defined in RFC 4318 as a managed object
C. The PAgP+ or LACP protocols are used to maintain the operational state of the VSS devices
D. A VSS interoperates with a virtual port channel
E. The 802.1Q or ISL protocols are used to maintain the operational state of the VSS devices
F. A VSS increases the size of the spanning-tree domain
您可能感興趣的試卷
你可能感興趣的試題
A.telnet 11.1.1.4 /vrf-source red
B.telnet 11.1.1.4 source /vrf red
C.telnet 11.1.1.4 /source vrf red
D.telnet 11.1.1.4 /vrf red
E.telnet 11.1.1.4 vrf red
A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table
A.ip vrf CCIE
B.ipv6 vrf CCIE
C.vrf definition CCIE
D.ipv6 vrf definition CCIE
Refer to the exhibit. From the MAC addresses shown in the command output， to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？ （）
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
A.0
B.1
C.255
D.256
最新試題
What is the correct command to set the router ID for an OSPFv3 process？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one？（）
Which three message types are valid PIMv2 message types？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）