單項選擇題Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link? ()

A. anycast address
B. site-local multicast
C. global address of the link
D. unique local address
E. link-local address


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which two combinations are valid PAgP configurations that will set up a PAgP channel?()

A.On-Passive
B.On-Auto
C.Passive-Active
D.Desirable-Auto
E.Active-Active
F.Desirable-Desirable

2.單項選擇題Which information is carried in an OSPFv3 intra-area-prefix LSA? ()

A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information

3.單項選擇題Which of these statements best describes the major difference between an IPv4-compatible tunnel and a 6to4 tunnel? ()

A. An IPv4-compatible tunnel is a static tunnel, but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers, but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains, but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel, the ISP assigns only IPv4 addresses for each domain, but for a 6to4 tunnel, the ISP assigns only IPv6 addresses for each domain.

5.單項選擇題Which of these best identifies the types of prefixes a router running BGP will advertise to an EBGP peer? ()

A. prefixes received from any other BGP peer and prefixes locally originated via networkstatements or redistributed to BGP
B. all prefixes in its IP routing table
C. only prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. only prefixes received from EBGP peers and prefixes received from route reflectors
E. all prefixes in its routing table except the prefixes received from other EBGP peers
F. all prefixes in its routing table except the prefixes received from other IBGP peers

最新試題

Choose two commands that are required to enable multicast on a router, when it is known that thereceivers use a specific functionality of IGMPv3.()

題型:多項選擇題

On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()

題型:單項選擇題

In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group?()

題型:單項選擇題

The classic Spanning Tree Protocol (802.1 D 1998) uses which sequence of variables to determine thebest received BPDU?()

題型:單項選擇題

Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()

題型:單項選擇題

What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()

題型:單項選擇題

In GLBP,which router will answer on client ARP requests?()

題型:單項選擇題

Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()

題型:單項選擇題

An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()

題型:單項選擇題

Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()

題型:單項選擇題