Refer to the exhibit. Routers A and B are directly connected and running OSPF， but they are unable to form a neighbor relationship. What is the most likely cause？（）
A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Routers A and B are directly connected and running EIGRP， but they are unable to form a neighbor relationship. What is the most likely cause？ （）
A. The network statements are misconfigured.
B. The IP address statements are misconfigured.
C. The autonomous system is misconfigured.
D. There is a physical issue with the cable.
Refer to the exhibit. Routers A and B are directly connected. Given the configuration， how many EIGRP routes will router B see in its routing table？（）
A. 0
B. 1
C. 2
D. 3
E. 4
A. LSA 1
B. LSA 3
C. LSA 4
D. LSA 5
E. LSA 7
A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas （external route）.
A.00000
B.12345
C.23456
D.65000
E.99999
最新試題
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which of the following is true about the MPLS header and its EXP field size？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）