A.access-list 50 deny 192.168.1.1 0.0.0.255
B.access-list 110 permit ip any any
C.access-list 2500 deny tcp any host 192.168.1.1 eq 22
D.access-list 101 deny tcp any host 192.168.1.1
您可能感興趣的試卷
你可能感興趣的試題
A.you can apply multiple access lists with the same protocol or in different direction.
B.you can config one access list,per direction,per layer 3 protocol
C.you can place as many access lists as you want on any interface
D.you can apply only one access list on any interface
A.They are always present in the NAT table.
B.They allow connection to be initiated from the outside.
C.They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D.They require no inside or outside interface markings because addresses are statically defined.
A.network or subnetwork IP address
B.broadcast address on the network
C.IP address leased to the LAN
D.IP address used by the interfaces
E.manually assigned address to the clients
F.designated IP address to the DHCP server
A.Set the IP gateway to be used by the network.
B.Perform host discovery used DHCPDISCOVER message.
C.Configure IP address parameters from DHCP server to a host.
D.Provide an easy management of layer 3 devices.
E.Monitor IP performance using the DHCP server.
F.Assign and renew IP address from the default pool.
A.The address is removed from the pool until the conflict is resolved.
B.The address remains in the pool until the conflict is resolved.
C.Only the IP detected by Gratuitous ARP is removed from the pool.
D.Only the IP detected by Ping is removed from the pool.
E.The IP will be shown, even after the conflict is resolved.
最新試題
What are two benefits of using a single OSPF area network design?（）
What are the three things that the Netflow uses to consider the traffic to be in a same flow ?（）
What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?（）
What authentication type is used by SNMPv2?（）
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?（）
Syslog was configured with a level 3 trap. Which 3 types of logs would be generated？（）
What SNMP message alerts the manager to a condition on the network?（）
What are three factors a network administrator must consider before implementing Netflow in the network?（）
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? （）
What are three reasons to collect Netflow data on a company network?（）