A. Each OSPF area requires a loopback interface to be configured.
B. Areas may be assigned any number from 0 to 65535.
C. Area 0 is called the backbone area.
D. Hierarchical OSPF networks do not require multiple areas.
E. Multiple OSPF areas must connect to area 0.
F. Single area OSPF networks must be configured in area 1.
您可能感興趣的試卷
你可能感興趣的試題
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.FTP
B.Telnet
C.SMTP
D.DNS
E.HTTP
F.POP3
A.192.168.20.29
B.192.168.20.16
C.192.168.20.17
D.192.168.20.31
E.192.168.20.0
A.255.255.255.0
B.255.255.255.128
C.255.255.252.0
D.255.255.255.224
E.255.255.255.192
F.255.255.248.0
Use the output from the router shown in the graphic above to determine which of the following are correct.（）
A. Router John uses a link-state routing protocol.
B. Router John will receive routing updates on the Serial0/0 interface.
C. Router John will receive routing updates on the Serial0/1 interface.
D. Router John will send routing updates out the Serial0/0 interface.
E. Router John will send routing updates out the FastEthernet0/0 interface.
F. Router John will send routing updates out the Serial0/1 interface.
最新試題
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which command displays the CHAP authentication process as it occurs between two routers?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）