A. Up to 25 m bus length
B. Only one device per SCSI bus
C. Up to 16 devices per SCSI bus
D. Half-duplex operation
E. Full-duplex operation
您可能感興趣的試卷
你可能感興趣的試題
A. Ethernet FCS
B. Source address
C. Destination address
D. EtherType
E. Protocol type
A. It is required to establish the point-to-point FCoE links with the first switch in the path.
B. It is required to establish the point-to-point FCoE links with any switch across multiple Ethernet segments.
C. It is not used to build the FCoE links.
D. It is used to ensure lossless transport.
A. Fibre Channel ports must be configured from the first port in the module.
B. Ethernet ports must be configured from the last port in the module.
C. Fibre Channel ports must be configured from the last port in the module.
D. Ethernet ports must be configured from the first port in the module.
A. LLDP transmit and receive are disabled
B. The initiator server has no connectivity to the target storage
C. FIP negotiation timing
D. Peer does not support LLDP
E. VSAN trunk protocol has been enabled
A. Server’s CNA does not support DCBX and PFC TLV was not negotiated.
B. A "no-drop" class has not been configured for FCoE
C. The system is running with the default QOS policies.
D. The link is oversubscribed.
最新試題
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B （Path C）. Which actions might be used to change this behavior？（）
Which is true when describing a connection replication in Cisco ACE？（）
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
Which GSS "source access list" is used to allow access to GSS by clients when GSS is being used as the DNS？（）
An administrator creates a vNIC and assigns it to Fabric A with the fabric failover feature enabled. Which statement is true？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
When will an "all configuration" backup be imported into the Cisco UCS Manager？（）
Which statement is true regarding Backup tasks in Cisco UCS？（）
Which of the following are supported in Cisco Global Site Selector？ （）