單項選擇題

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）

A.The OSPF area is not configured properly.
B.The priority on R1 should be set higher.
C.The cost on R1 should be set higher.
D.The hello and dead timers are not configured properly.
E.A backup designated router needs to be added to the network.
F.The OSPF process ID numbers must match.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）

A.Telnet to WANRouter and execute the command show interfaces S0/0
B.Telnet to WANRouter and execute the commandshow processes S0/0
C.Telnet to WANRouter and execute the command show running-configuration
D.Telnet to WANRouter and execute the command show controller S0/0
E.Physically examine the cable between WANRouter S0/0 and the DCE.
F.Establish a console sessionon WANRouter and execute the command show interfaces S0/0

4.單項選擇題

The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?（）
 

A.The Gallant router has the wrong LMI type configured
B.Inverse ARP is providing the wrong PVC information to the Gallant router
C.The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command
D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
E.The IP address on the serial interface of the Attalla router is configured incorrectly

5.單項選擇題How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?（）

A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface
B.Configure each Frame Relay circuit as apoint-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces