A. show secure
B. show file systems
C. show flash
D. show version
您可能感興趣的試卷
你可能感興趣的試題
A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B. Gateway-Router is configured to only receive RIPv2 updates.
C. Gateway-router is configured to receive only RIPv1 updates.
D. Branch-Router1 is configured to only send RIPv1 updates
A. 172.16.0.0/18
B. 172.16.0.0/16
C. 172.16.0.0/20
D. 172.16.0.0/21
A. 2 through 1001
B. 1 through 1001
C. 1 through 1002
D. 2 through 1005
A. (config-if)#authentication ppp chap fallback ppp
B. (config-if)#authentication ppp chap pap
C. (config-if)#ppp authentication chap pap
D. (config-if)#ppp authentication chap fallback ppp
A. Bandwidth,Delay,and MTU
B. Bandwidth
C. Bandwidth and MTU
D. Bandwidth , MTU,Reliability,Delay,and Load
最新試題
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
What is the purpose of the cisco Vlan Trunking protocol?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
At which layer of the OSI model is RSTP used to prevent loops?()
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()