A. Router(config)#password-encryption
B. Router(config)#service password-encryption
C. Router#service password-encryption
D. Router# password-encryption
您可能感興趣的試卷
你可能感興趣的試題
A. IETF
B. HDLC
C. Q9333-A Annex A
D. ANSI Annex D
A. 120
B. 100
C. 90
D. 110
A. FF02::A
B. FF05::101
C. FF02::9
D. FF02::6
A. Automatic summarization at classful boundries can cause problems on discontinuous subnets
B. EIGRP and OSPF are classful routing protocols and summarize routes by default
C. RIPv1 and OSPF are classless routing protocols
D. Classful routing protocols send the subnet mask in routing updates
A. Cisco IOS IPsec/SSL VPN client
B. Cisco VPN Clinet
C. ISDN terminal adapter
D. Cisco Adaptive Security Appliance
最新試題
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which command displays the CHAP authentication process as it occurs between two routers?（）