多項選擇題While troubleshooting an EIGRP routing problem you notice that one of the company routers havegenerated a large number of SIA messages. What are two possible causes for EIGRP Stuck-In-Active routes?()

A.Some query or reply packets are lost between the routers
B.The neighboring router starts receiving route updates from this router
C.A failure causes traffic on a link between two neighboring routers to flow in only one direction(unidirectional link)
D.The neighboring router stops receiving ACK packets from this router


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. EIGRP has been configured on routers R1 and R2. However, R1 does notshow R2 as a neighbor and does not accept routing updates from R2. What could be the cause ofthe problem?()

A.The no auto-summary command has not been issued under the EIGRP process on bothrouters
B.Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24
C.EIGRP cannot exchange routing updates with a neighbor’s router interface that is configuredwith two IP addresses
D.EIGRP cannot form neighbor relationship and exchange routing updates with a secondaryaddress

2.單項選擇題


Based on the above configuration, which of the following BGP statements would inject the 10.10.0.0/16 prefix into the BGP routing table()

A.network 10.0.0.0
B.network 10.10.0.0 mask 255.255.0.0
C.network 10.10.10.1 mask 255.255.255.255
D.network 10.10.10.0 mask 255.255.255.0
E.network 10.0.0.0 mask 255.255.0.0

4.單項選擇題The PassGuide network consists of a series of routers that are all configured for IBGP. Which one of the following IBGP characteristics is true()

A.The IBGP routers must always be fully meshed.
B.The IBGP routers can be in a different AS.
C.The IBGP routers must be directly connected.
D.TThe IBGP routers do not need to be directly connected.
E.None of the other alternatives apply are true

5.多項選擇題

A network administrator is troubleshooting an EIGRP connection between RouterA, IP address10.1.2.1, and RouterB, IP address 10.1.2.2. Given the debug output on RouterA, which twostatements are true?()

A.RouterA received a hello packet with mismatched metric-calculation mechanisms
B.RouterA received a hello packet with mismatched authentication parameters
C.RouterA will form an adjacency with RouterB
D.RouterA received a hello packet with mismatched autonomous system numbers
E.RouterA received a hello packet with mismatched hello timers
F.RouterA will not form an adjacency with RouterB

最新試題

Drag the DSL local loop topic on the left to the correct descriptions on the right.

題型:問答題

Which statement about PPPoA configuration is correct?()

題型:單項選擇題

Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed?()

題型:單項選擇題

Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password?()

題型:多項選擇題

cisco ios command to interface dialer 0

題型:問答題

Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.(Not allstatements will be used)

題型:問答題

Router NetworkTut is configured as shown below:Given the above configuration, which statement is true?()

題型:單項選擇題

IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true?()

題型:多項選擇題

In computer security, AAA stands for authentication, authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct?()

題型:單項選擇題

Network Topology Exhibit:Configuration Exhibit:NET(config)# access-list 112 deny icmp any any echo logNET(config)# access-list 112 deny imp any any redirect logNET(config)# access-list 112 deny icmp any any mask-request logNET(config)# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET(config)# interface Fa0/1NET(config-if)# ip access-group 112 inYou work as a network administrator at networkTut.com, study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However, the configurationis incorrect. On the basis of the information in the exhibit, which configuration option wouldcorrectly configure router NET?()

題型:單項選擇題