A.192.168.30.1：0：0：0：0：0：0
B.0：0：0：0：0：0：192.168.30.1
C.：：192.168.30.1
D.C0A8：1E01：：
E.192.168.30.1：：
F.：：C0A8：1E01
您可能感興趣的試卷
你可能感興趣的試題
A.The route table is cleared. Then the OSPF neighbors are reformed
B.The OSPF adjacencies are cleared and initiated again
C.The OSPF database is repopulated and then the shortest path first （SPF） algorithm isperformed.
D.The shortest path first （SPF） algorithm is performed on the LSA database
E.None of the other alternatives apply
Refer to the exhibit. What two statements are true？（）
A.The IP address of the backup designated router （BDR） is FE80：：205：5FFF：FED3：5808
B.This is the designated router （DR） on the FastEthernet 0/0 link
C.Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command
D.OSPF version 2 has been enabled to support IPv6
E.The output was generated by the show ip interface command
Refer to the output. What IOS command produces this output？（）
A.show ip ospf
B.show ip ospf interface
C.show ipv6 ospf interface
D.show ipv6 ospf
Refer to the exhibit. Assume that Switch_A is active for the standby group and the standby devicehas only the default HSRP configuration. What conclusion is valid？（）
A.If port Fa1/1 on Switch_A goes down， the standby device will take over as active
B.If the current standby device were to have the higher priority value， it would take over the role ofactive for the HSRP group
C.If Switch_A had the highest prioritynumber， it would not take over as active router
D.If port Fa1/1 on Switch_A goes down， the new priority value for the switch would be 190
Network topology exhibit：
In this network segment， the two routers on the network are configured for GLBP （Gateway LoadBalancing Protocol）. What can be said about this？（）
A.The hosts will have different default gateway IP addresses and different MAC addresses foreach rtouter
B.The default gateway address of each host should be set to the virtual IP address
C.The hosts will learn the proper default gateway IP address from Router R1
D.The default gateway address of each host should be set to the real IP address of the router
E.None of the other alternatives apply
最新試題
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Drag and drop each management protocol on the above to the correct category on the below.
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Which statement about PPPoA configuration is correct？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.