A.Eliminate potential causes
B.Collect information
C.Document causes
D.Hypothesize underlying causes
E.Verif/ hypothesis
F.Examine collected information
您可能感興趣的試卷
你可能感興趣的試題
A.The adjacency table is populated from a router’s ARP cache
B.CEF does not require the first packet of a data flow to be process switched
C.CEF maintains the Forward Information Base and the adjacency table
D.CEF can be enabled with the interface command ip cef
E.The FIB is populated from a router’s IP routing table
F.On most router platforms CEF is enabled by default
A.CEF switching is disabled on the switch
B.The source device and destination device are in different VLANs
C.The VLAN is excluded from the trunk
D.The host is connected to the switch through an IP phone
E.A faulty cable from host to switch or between switches
F.The trunking encapsulation type is inconsistent on the two ends of the link
A.Cisco Express Fonvarding
B.FIB switching
C.Cache switching
D.Optimized switching
E.Process switching
F.Fast switching
A.Fault management
B.Accounting management
C.Operations management
D.Performance management
E.Security management
F.Configuration management
A.sh ip route
B.sh ip cef 〈ip_address〉
C.sh adjacency 〈ip_address〉
D.sh ip route 〈ip_addres$〉
E.sh ip adjacency 〈/p_address〉
F.sh ip cef 〈mac_addrQss〉〈ip_address〉
最新試題
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Drag and drop each management protocol on the above to the correct category on the below.
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
cisco ios command to interface dialer 0
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Match the xDSL type on the above to the most appropriate implementation on the below.