A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
您可能感興趣的試卷
你可能感興趣的試題
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.ja1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.problem management
B.configuration management
C.incident management
D.change management
A.technology assessment
B.operations assessment
C.security assessment
D.security administration
E.change management
A.15
B.10
C.1
D.5
A mobility group is created by a cisco wlcm and 4402 series wireless lan controller. A client that is anchored on the cisco wlcm roams to an access point on the 4402 controller. you then run a debug command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’s perspective？（）
A.received mobile anchor export message
B.transmit plumbing duplex mobility tunnel message
C.received plumbing duplex mobility tunnel message
D.transmit mobile anchor export message
最新試題
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）