A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
您可能感興趣的試卷
你可能感興趣的試題
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position， in feet， from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
最新試題
How is attenuation measured？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
Which class of Cisco access points operate under IEEE 802.3af power？（）
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis？ （）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
Which format can NOT be imported into Cisco WCS Planning Tool？（）
Given the correct input parameters， the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses？ （）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？