When configuring vlans on an autonomous access point.
What must be configured on the connected switchport?()
A.802.1q trunking
B.vtp trunking
C.isl trunking
D.dpt trunking
您可能感興趣的試卷
你可能感興趣的試題
There are 30 managed access points on the wlse. a radio scan is started but fails. Upon
inspection of the device list in the reports tab, you notice a red indicator on the wds access point. upon inspection of the wds access point through its guid, it is discovered that the security keys are not set up between the wds access point and the wlse.
Which of the following is mis configured?()
A.snmp communities
B.telnet/ssh user/password
C.wlccp credentials
D.http user/password
You are using adu and are authenticated and associated to an access point. you are unable to obtain an ip address.
Which of the following will cause this problem?()
A.aes encryption enabled
B.tkip enabled
C.third-party wireless supplicant enabled
D.802.1x authentication type enabled
On a series 1010 lightweight access point, the alarm led is flashing red, and all other leds are off.
What is the lightweight access point indicating?()
A.it has lost contact with controller.
B.its ip address already exists.
C.it requires a code upgrade.
D.it is operating normally.
A.router# show wlccp ap
B.router# show wlccp wds ap
C.router# show wlccp cckm
D.router# show wlccp wds cckm
A.dictionary
B.bit-flip and replay
C.mac spoofing
D.man-in-the-middle
最新試題
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but, when you answer, the call is dropped.What may cause this problem?()
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor,4GB RAM, and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem?()
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is, you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to?()
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective?()
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter,the status LED and activity LED are alternating on and off.What does this indicate?()
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together.What does this indicate about the access point?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller?()
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast?()