Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()
A. Do not fragment has been configured on PE11.
B. MPLS has been disabled on routers P11 and P12.
C. An access list has been created on P11 to block traceroutes from PE11.
D. The no mpls ip propgate-ttl local command has been configured on PE11
E. ICMP has been disabled on the intermediary routers between PE11 and PE12.
您可能感興趣的試卷
你可能感興趣的試題
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)
A. A router connected to the fastethemet 1/4 interface will be able to communicate with hosts connected to interface fastethemet 1/1,1/2, and 1/3.
B. A router connected to the fastethemet 1/4 interface will not be able to communicate with the host connected to interface fastethemet 1/3.
C. Hosts connected to interface fastethemet 1/1 and 1/2 can communicate with each other.
D. Hosts connected to interface fastethemet 1/1,1/2, and 1/3 can communicate with each other.
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.
Which two best-practice actions can you take to overcome this problem? ()(Choose two.)
A. Turn off MST (802.1s) on all switches.
B. Turn on MST (802.1s) on all switches.
C. Turn on RSTP (802.1w) on all switches.
D. Turn off RSTP (802.1w) on all switches.
Refer to the exhibit. Which two of these statements are correct? (Choose two.)()
A. PE11 originated label 20.
B. PE11 originated label 21.
C. ThePE11 upstream neighbor originated label 21.
D. The PE11 downstream neighbor originated label 20.
E. PE11 will append label 21 to incoming packets labeled 32.
F. PE11 will impose label 20 on incoming packets labeled 32.
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.
In the exhibit you can see the output of the show ip ospf neighbor detail command.
Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()
A. Stateful Switchover for Cisco Nonstop Forwarding only works with BGP.
B. Stateful Switchover for Cisco Nonstop Forwarding must be configured on all adjacent routers.
C. Cisco Nonstop Forwarding with Stateful Switchover helper mode is not supported on the adjacent router.
D. Cisco Nonstop Forwarding with Stateful Switchover helper mode for OSPF has been promiscuousstandardized and is supported on the adjacent router.
Refer to the exhibit. Which two of these events will be the result of issuing the above command? ()(Choose two.)
A. 64-bit IPv4 prefix will be created.
B. The route distinguisher will be used to indicate VPN membership.
C. Extended BGP communities will be used to encode route distinguishers.
D. A 96-bit VPNv4 prefix will be created and propagated across the IP network.
E. The route distinguisher is 64 bits and will be prepended to an existing IPv4 route to make it globally unique.
最新試題
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()
What are four advantages to using tunnel brokers in an IPv6 transition environment?()
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?()
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()
Which three of these items are IPv6 transition mechanisms? ()(Choose three.)
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?()
What is the purpose of using VPN hardware acceleration equipment?()
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?()