單項選擇題Which of the following statements explains why it is normally best to have more than one controller-basedaccess point participate in the containment of one rogue access point?()

A.Multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
B.Clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
C.Each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
D.Clients connected to the rogue access point must be able to connect to the containment controller-based access point.


您可能感興趣的試卷

你可能感興趣的試題

4.單項選擇題

In a deployment using standalone access points, clients set up to authenticate with EAP-PEAP or EAP-Cisco Wireless (Cisco-LEAP) cannot authenticate. When you inspect the Failed Attempts report on theCisco Secure ACS, you find this error: "Unknown network access server NAS." 
Which problem may havecaused this failure?()

A.misconfigured EAP type on the access point
B.misconfigured EAP type on the AAA server
C.misconfigured IP address of the access point on the AAA server
D.misconfigured IP address of the AAA server on the access point

最新試題

You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together.What does this indicate about the access point?()

題型:單項選擇題

When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()

題型:多項選擇題

You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side,which of the following actionsshould you perform on the wired infrastructure?()

題型:單項選擇題

A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective?()

題型:單項選擇題

You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference?()

題型:單項選擇題

The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days?()

題型:單項選擇題

You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()

題型:單項選擇題

You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is, you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to?()

題型:單項選擇題

On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter,the status LED and activity LED are alternating on and off.What does this indicate?()

題型:單項選擇題

A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor,4GB RAM, and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem?()

題型:單項選擇題