A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
您可能感興趣的試卷
你可能感興趣的試題
A. two IP addresses， one for each supervisor
B. three IP addresses， one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none—management 0 will use the IP address from the first SVI that is created
A. Receive port： Enabled， Transmit port： Enabled
B. Receive port： Enabled， Transmit port： Desired
C. Receive port： Enabled， Transmit port： Disabled
D. Receive port： Disabled， Transmit port： Desired
E. Receive port： Desired， Transmit port： Desired
A. NX-OS uses a random MAC address from the IEEE OUI block that is assigned to Cisco.
B. The VDC system MAC is pulled from the active supervisor and concatenated through a hash to ensure uniqueness.
C. NX-OS uses a value that is based on a range that is assigned to the SPROM of the system backplane.
D. The VDC system MAC is based on a range that is allocated to the first line card that is installed in the switch.
A. The module is powered up， and interfaces are in an "admin down" state.
B. The module is denied power， and a syslog message is generated.
C. The module is powered up， and interfaces are allocated to VDC0.
D. The module is powered up， and interfaces are allocated to VDC100.
A. Compatibility with third-party Fibre Channel switches
B. Faster throughput
C. Reduce domain IDs in a Fibre Channel environment
D. Support for increased number of VSANs
E. Support for SAN port channels
最新試題
An administrator is creating a service profile but receives an error when applying to a blade. The administrator checks the faults tab of the service profile and finds the following error （Refer to the exhibit）.What is the cause of this error？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
A Cisco UCS fabric interconnect in end-host mode learns MAC addresses on which port types？（）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
Which two statements about end-host mode in SAN connectivity in a Cisco UCS environment are true？ （）
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
Which GSS "source access list" is used to allow access to GSS by clients when GSS is being used as the DNS？（）
Server load balancing （SLB） is the process of deciding to which server a load-balancing device should send a client request for service. Which predictors are supported on ACE in order to select the best server to fulfill a client request？ （）