您可能感興趣的試卷
你可能感興趣的試題
Refer to exhibits 1 and 2. In exhibit 1,all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2,the network management team reported that there is no utilization on the WAN link B. To solve this problem,you decide to change the logical topology of your LAN,but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design,automatic redundancy,and load balancing. Which one of these actions would be the best choice?()
A.Use MHSRP,with three users using router A as the default gateway and three users using router B as the default gateway.
B.Keep HSRP and activate PBR to redirect half of the traffic to the other WAN link.
C.Use the backup interface on the WAN link B to provide load balancing for all users.
D.Use GLBP instead,because it provides you with up to three MAC addresses for the same default gateway virtual IP address.
E.Use GLBP instead,because it provides you with up to four MAC addresses for the same default gateway virtual IP address.
Refer to the exhibit. When applying this hierarchical policy map on the on the tunnel1 interface, you measure high jitter for traffic going through class 1234. What is the most likely cause of this jitter?()
A.The configuration of a hierarchical policy map on a tunnel interface is not supported.
B.Class 5555 and class 5554 are both taking up 100% of the bandwidth, leaving nothing for class 1234.
C.The burst size for the traffic shaping is wrongly configured to 15000; this would require an interface capable of sending at 150Mb/s.
D.The burst size for the traffic shaping has been wrongly configured; it should be set as low as possible.
E.The burst size for the traffic shaping has been wrongly configured; it should be set as high as possible.
A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work?
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
最新試題
SPT初始狀態之后的一個狀態是什么?
four switches, which one will be root switch.(no pic).
Which of the following are key characteristics of PPP?()
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?()
hsrp speak狀態是什么意思?
DHCP SERVER在給一個網段設置POOL時,該網段路由器接口地址能不能放入POOL,能why,不能why。
一堆交換機一個server、一個transpare,問配置prune在哪里配置?
What is method list for configure aaa?