A.Devices use DHCP to request their VLAN.
B.Attached devices are unaware of any VLANs.
C.Devices are assigned to VLANs based on their MAC addresses.
D.Devices are in the same VLAN regardless of which port they attach to.
您可能感興趣的試卷
你可能感興趣的試題
A.VMPS server lookup is required
B.Easy to configure
C.Easy of adds,moves,and changes
D.Based on MAC address of the connected device
Given the above partial configuration, which two statements are true about VLAN traffic?()
A.VLANs 1-5 will use fa0/10 as a backup only.
B.VLANs 6-10 will use fa0/10 as a backup only.
C.VLANs 1-5 will be blocked if fa0/10 goes down.
D.VLANs 1-10 are configured to load share between fa0/10 and fa0/12.
E.VLANs 6-10 have a port priority of 128 on fa0/10.
A.Configuration revision number
B.Configuration revision flag field
C.Configuration revision reset switch
D.Configuration revision database
E.None of the other alternatives apply
A.VLAN 1003
B.VLAN 1
C.VLAN ON
D.VLAN A
E.VLAN 0
A.optimized transport structure
B.high port density
C.boundary definition
D.data encryption
E.local VLANs
F.route summaries
最新試題
Which two statements are true when the extended system ID feature is enabled? ()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
Refer to the exhibit. For what purpose is the command show ip cef used?()
Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
Which three statements about STP timers are true?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()