單項選擇題What is the OSPF default frequency,in seconds,at which a cisco router sends hello packets on a multi-access network?()

A. 10
B. 40
C. 30
D. 20


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which dose the frame-relay interface-dlci command configure?()

A. remote DLCI on the main interface
B. local DLCI on the main interface
C. local DLCI on the subinterface
D. remote DLCI on the subinterface

2.單項選擇題Which command can be a router to verify the layer 3 path to a host?()

A. traceroute address
B. tracert address
C. ssh address
D. telnet address

4.單項選擇題A network administrator receives an error message while tring to configure the Ethernet interface of a router with IP address 10.24.24.24/29.which statement explains the reason for this issue?()

A. The address is a broadcast address
B. The Ehernet interface is faulty
C. VLSM-capable routing protocols must be enable first on the router.
D. This address is a network address.

5.單項選擇題What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology?()

A. lowest port MAC address
B. port priority number and MAC address.
C. VTP revision number
D. highest port priority number.
E. path cost

最新試題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:單項選擇題

Which command displays the CHAP authentication process as it occurs between two routers?()

題型:單項選擇題

Which command encrypts all plaintext passwords?()

題型:單項選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題

At which layer of the OSI model is RSTP used to prevent loops?()

題型:單項選擇題

Three access ports have been installed and configured to a small office.What term defines the wireless topology?()

題型:單項選擇題

What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

題型:單項選擇題