單項選擇題Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over FastEthernet?（）

A. 802.3ad
B. 802.1w
C. 802.1Q
D. 802.1d


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which command helps a network administrator to manage memory by displaying flash memory and NVRAM utilization?（）

A. show secure
B. show file systems
C. show flash
D. show version

2.單項選擇題What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?（）

A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B. Gateway-Router is configured to only receive RIPv2 updates.
C. Gateway-router is configured to receive only RIPv1 updates.
D. Branch-Router1 is configured to only send RIPv1 updates

3.單項選擇題which address range efficiently summarizes the routing table of the addresses for router main?（）

A. 172.16.0.0/18
B. 172.16.0.0/16
C. 172.16.0.0/20
D. 172.16.0.0/21

4.單項選擇題assuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?（）

A. 2 through 1001
B. 1 through 1001
C. 1 through 1002
D. 2 through 1005

5.單項選擇題which command is used to enable CHAP authentication whit PAP as the fallback method on a serial interface?（）

A. (config-if)#authentication ppp chap fallback ppp
B. (config-if)#authentication ppp chap pap
C. (config-if)#ppp authentication chap pap
D. (config-if)#ppp authentication chap fallback ppp

最新試題

Which IPsec security protocol should be used when confidentiality is required?（）

題型：?jiǎn)雾?xiàng)選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）

題型：?jiǎn)雾?xiàng)選擇題

At which layer of the OSI model dose PPP perform?（）

題型：?jiǎn)雾?xiàng)選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型：?jiǎn)雾?xiàng)選擇題

Which command is used to display the collection of OSPF link states?（）

題型：?jiǎn)雾?xiàng)選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）

題型：?jiǎn)雾?xiàng)選擇題

A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）

題型：?jiǎn)雾?xiàng)選擇題

Which statement describes the rule of split horizon?（）

題型：?jiǎn)雾?xiàng)選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）

題型：?jiǎn)雾?xiàng)選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）

題型：?jiǎn)雾?xiàng)選擇題