單項選擇題

Refer to the exhibit. PCs in VLAN 2 are not able to communicate with PCs in VLAN 3.
 What could  be the cause?()

A. IP routing is not enabled.
B. VTP is not configured correctly on the interfaces.
C. The command mls rp management-interface is missing.
D. The command mls rp ip must be disabled to enable the routing.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

You are configuring a Cisco multilayer switch for the Company network.
 Which command would  you use to configure a port to act as a routed interface?()

A. ip routing
B. switchport mode trunk
C. no switchport
D. switchport trunk native vlan 1
E. None of the other alternatives apply

2.多項選擇題

Which of the following could be used to provide a Layer 3 data path between separate VLANs?()

A. VLAN trunking
B. An external router
C. An internal route processor
D. VLAN capable bridge
E. EtherChannel

3.多項選擇題

Inter-VLAN routing has been implemented in the Company network. In VLAN routing, 
what are  some of the disadvantages of designing a router-on-stick configuration? ()

A. InterVLAN routing cannot be filtered by the router.
B. The router becomes a single point of failure for the network.
C. Routers will not route STP BPDUs.
D. There is a possibility of inadequate bandwidth for each VLAN.
E. Additional overhead on the router can occur.
F. NetFlow Switching is required for InterVLAN accounting.

4.單項選擇題

The Company network needs to pass traffic between VLANs. 
Which device should be used to  accomplish this? ()

A. Hub
B. Switch
C. Router
D. Bridge
E. None of the other alternatives apply

5.單項選擇題

pany has implemented numerous multilayer switches that utilize FIB tables. 
Which statement  is true about the Forward Information Base (FIB) table?()

A. The FIB is derived from the IP routing table and is optimized for maximum lookup throughput.  
B. The FIB table is derived from the Address Resolution Protocol table, and it contains Layer 2  rewrite (MAC) information for the next hop.
C. When the FIB table is full, a wildcard entry redirects traffic to the Layer 3 engine.
D. The FIB lookup is based on the Layer 2 destination MAC address.
E. None of the other alternatives apply

最新試題

Which three statements about STP timers are true?()

題型:多項選擇題

Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()

題型:單項選擇題

Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statements about the STP process for VLAN 200 are true? ()

題型:多項選擇題

What two things will occur when an edge port receives a BPDU?()

題型:多項選擇題

Refer to the exhibit. For what purpose is the command show ip cef used?()

題型:單項選擇題

Which router redundancy protocol cannot be configured for interface tracking?()

題型:單項選擇題

Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()

題型:單項選擇題

Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()

題型:單項選擇題

How are STP timers and state transitions affected when a topology change occurs in an STP environment?()

題型:單項選擇題

Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port:00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5 (not half  duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B) 0/4 (half duplex). What would be the possible outcome of the problem?()

題型:單項選擇題