單項選擇題Which form of DSL technology is typically used as a replacement for T1 lines?()

A.VDSL
B.HDSL
C.ADSL
D.SDSL


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Refer to the exhibit.

Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel?()

A.The command access-list 110 permit gre must be configured to specify which traffic will be encrypted.
B.The command access-list 110 permit ip must be configured to specify which hosts can use the tunnel.
C.The tunnel destination 172.17.63.18 command must be configured on the Tunnel0 interface.
D.The tunnel mode gre command must be configured on the Tunnel0 interface.
E.The tunnel source Ethernet1 command must be configured on the Tunnel0 interface.
F.The tunnel source Tunnel0 command must be configured on the Tunnel0 interface.

2.多項選擇題What are three configurable parameters when editing signatures in Security Device Manager (SDM)?()

A.AlarmSeverity
B.AlarmKeepalive
C.AlarmTraits
D.EventMedia
E.EventAlarm
F.EventAction

3.多項選擇題Which two statements are true about broadband cable (HFC) systems?()

A.Cable modems only operate at Layer 1 of the OSI model.
B.Cable modems operate at Layers 1 and 2 of the OSI model.
C.Cable modems operate at Layers 1, 2, and 3 of the OSI model.
D.A function of the cable modem termination system (CMTS) is to convert the modulated signal from the cable modem into a digital signal.
E.A function of the cable modem termination system is to convert the digital data stream from the end user host into a modulated RF signal for transmission onto the cable system.

4.多項選擇題Which two mechanisms can be used to detect IPsec GRE tunnel failures?()

A.Dead Peer Detection (DPD)
B.CDP
C.isakmp keepalives
D.GRE keepalive mechanism
E.The hello mechanism of the routing protocol across the IPsec tunnel

5.單項選擇題

Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown?()

A.The route-target both 100:2 command sets import and export route-targets for vrf2.
B.The route-target both 100:2 command changes a VPNv4 route to a IPv4 route.
C.The route-target import 100:1 command sets import route-targets routes specified by the route map.
D.The route-target import 100:1 command sets import route-targets for vrf2 that override the other route-target configuration.

最新試題

Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown?()

題型:單項選擇題

Which form of DSL technology is typically used as a replacement for T1 lines?()

題型:單項選擇題

Refer to the exhibit. Which statement about the authentication process is true?()

題型:單項選擇題

Which three categories of signatures can a Cisco IPS microengine identify?()

題型:多項選擇題

If an edge Label Switch Router (LSR) is properly configured,which three combinations are possible?()

題型:多項選擇題

Which statement is true when ICMP echo and echo-reply are disabled on edge devices?()

題型:單項選擇題

What is a reason for implementing MPLS in a network?()

題型:單項選擇題

Refer to the exhibit. What type of security solution will be provided for the inside network?()

題型:單項選擇題

Which statement describes the Authentication Proxy feature?()

題型:單項選擇題

During the Easy VPN Remote connection process,which phase involves pushing the IP address, Domain Name System (DNS),and split tunnel attributes to the client?()

題型:單項選擇題